Saturday, October 4, 2008

Maximum combinational path delay: No path found

In the Design Summary, under Synthesis Report (Timing Summary heading), I always see this list:

Minimum period:
Minimum input arrival time before clock:
Maximum output required time after clock:
Maximum combinational path delay:

The last item interests me most (among the four) since it sometimes gives me this: 

Maximum combinational path delay: No path found.

I do not know whether this is good. So I checked. In a Xilinx forum, expert contributor gszakacks said,

---
Quote:

This is normal if there is no path from a top-level input to a top-level output that is not clocked. I assume your design is fully pipelined, thus no combinatorial paths from input to output?
---

According to a Xilinx ModelSim Simulation Tutorial from Computer and Information Science, University of Pennsylvania

---
Quote:

Maximum combinational path delay...is the maximum delay for signal propagation in your design, so changing signals faster than [this] will result in unexpected behavior.
---

They have an example there (Timing Simulation: Combinational Logic Section 2), where they made the signal transition faster which resulted in simulation failure - the output signals do not match the input signals because the inputs change too fast.

1 comment:

Amritha Devadiga said...

Buy Electronic Components in Online for affordable prices at Component Buy. Get 25% discount on Semiconductor micro controller relays Connectors and many more